玫瑰心宇宙情心靈工作坊

How to Draw the Sacred Geometry, Metatron’s Cube Step by Step

 “The Flower of Life” and “Metatron’s Cube” are the basic components of the matters: the former tends to be more feministic, while the latter, masculine. Through the figure of “The Flower of Life”, the negative emotions can be cleaned and the deeds from many lifetimes can be healed. In this way, one can restore into “the real I” and “the true I”.

Metatron is a Archangel of universe. His energy expands outwardly into the universe and affects different dimensions. Our universe is like an orchestra: the source is the composer, while Metatron is the conductor. Now, he is focused on Earth because it is the only planet that is out of tune for the moment. Metatron is trying to tune up rapidly as to play again the harmonic symphony! ----- Excerpt from Life Potential Publications’ book.

How to Draw the Sacred Geometry, Metatron’s Cube Step by Step

Step 1:

Use a compass to draw a 4cm radius circle in the middle of an A4 paper. Please do not press the compass too hard as it shall be erased later, just clear enough to be recognized.

Step 2:

 Set the compass with 4cm radius on the point of intersection of the vertical line through the center and the circumference (the cross in the diagram), then make a mark on the circumference. Use the mark as the new center and make another mark on the circumference. Repeat the same process until there are total six marks on the circumference. Please do not press the compass too hard as it shall be erased later.

Step 3:

Connect all the six marks with straight lines and erase all the marks and the circle.

If it is not easy to erase, use the board above as an assistant. You can purchase it for around 10 dollars in the bookstore.

After erasing the circle and the marks, you will get a regular hexagon.

Step 4:

Use all six endpoints of the hexagon and the very first center as the centers to create seven 2cm radius circles and all the circles will be tangent because of the principle of geometry.

Step 5:

Set a ruler align with the centers of the three vertical circles. Make a 4cm mark above the endpoint of the hexagon (the cross in the diagram). Use the compass and set the mark as the center to draw a 2cm circle. The circle is tangent and its center is vertical aligned with the centers of the three.

Repeat the same procedures five times to create total six outer circles.

Step 6:

Connect all the six circle centers with straight lines to get a regular hexagon on the outside of the first regular hexagon.

Step 7:

Connect the endpoint on the top of outside hexagon with straight line to the bottom left corner and the bottom right corner of the inside hexagon. Repeat the same process five times to come up the following.

Please do not miss any endpoint as it would be difficult to correct.

Step 8:

Connect the centers of outter circlesthat facing each other and the centerof diagonal circle to create a star of David (Merkaba).

Then connect the centers of inner circles that facing each other and the centher of diagonal circle to create a star of David (Merkaba).

Now, you complete “The Sacred Geometry Metatron’s Cube”!