.  

Draw the Sacred Geometry “The Flower of Life” Step by Step

 

 

 

 

“The Flower of Life” and “Metatron’s Cube” are the basic components of the matters: the former tends to be more feministic, while the latter, masculine. Through the figure of “The Flower of Life”, the negative emotions can be cleaned and the deeds from many lifetimes can be healed. In this way, one can restore into “the real I” and “the true I”.

 

 

 生命之花  

 

People would not know where and how to start, because the structure of “The Flower of Life” is complicated. Here, we provide a sequential drawing approach to guide you through. In simple words, we draw a line of five circles, two lines of four circles and two lines of three circles. It adds up to total 19 circles. The details are as following

 

Step 1:

 

 

 

步驟1.jpg    

 

First, draw a circle with a compass at the center point on an A4 paper. To use the commended radius, 2cm is not to be tilt easily and the completed “The Flower of Life” would perfectly fit in on an A4 size paper. Then on the circumference, mark two “X” parallel to the center.

 

Step 2:

 

 

 

步驟2.jpg    

 

Using the two marked sings as centers to draw two other circles (all circles should be 2cm radius). Be cautious not to change the radius of the compass, or the deviation will increase in an obvious way.

 

Step 3:

 

 

 

步驟3.jpg    

 

Repeat Step 1 on those two outer circles and create another two circles. Now, you complete the first five circles are aligned each other’s center.

 

Step 4:

 

 

 

步驟4(1).jpg    

 

Use the intersection of every two circumferences (the mark in the diagram) as the center to create new circle and check if the cut is right on the both centers of the two circles below and the new circle’s circumference cuts on the intersection of the two circumferences on the right. If it is off too much, please modify or even redraw.

 

 

步驟4(2).jpg    

 

 

 

Repeat Step 4 to create total four circles each on both upper and lower part where the intersection of the circumferences as the center of the circles.

 

Step 5:

步驟5(1).jpg    

Then repeat Step 4 on the intersections of the four circles’ circumferences to create new circles.

 

 

步驟5(2).jpg  

 

Complete three circles each on the upper and lower part where the intersection of the circumferences as the center of the circles.

   

Step 6:

 

 步驟6.jpg    

 

 

Now comes the complicated part. Use the outer circles’ intersection as the center (marks in the diagram) to draw half circle in side of the circles to complete the petals.
There should be 12 half-circles to be drawn and please be sure not to miss any of them.

 

 

Step 7:

步驟7      

 

 

 

TTake the six tips of the petals as the centers (the “x” in the diagram) and create one-third circle on the inside to complete more petals. There should be six of one-third circles in this process.

 

Step 8:

步驟7.jpg    

 

 

 

Here comes to the most troublesome part. In order to complete the rest of the petals on the outermost periphery, we need to mark the centers outside of “The Flower of Life” and then draw one sixth of the circles from those 18 centers. By taking every two tips of petals right next to one another as centers and draw arcs crossed each other as the centers, then using the centers to draw one sixth of the circles inwardly to complete the rest of 18 petals.

 

 

生命之花    

   “The Flower of Life”

 

At the last, use the very first circle center and draw a 6cm-radius-concentric circle corresponded with the six outermost tips. Now, you successfully complete a sacred geometry “The Flower of Life”!

arrow
arrow
    全站熱搜

    BHBH6886 發表在 痞客邦 留言(0) 人氣()